MG MGC: an MGB with a straight-six, and a reputation it never deserved (1967-1969)

Few cars MG ever built were as misjudged as the MGC, the MGB given two extra cylinders. From the outside it looks almost exactly like an MGB, but under that bulging bonnet sits a 3.0-litre straight-six, and the car was meant to be a fast, long-legged grand tourer to replace the big Austin-Healey 3000. The motoring press of the day gave it a kicking, but time has been kinder, and a good one is now a sought-after and still relatively affordable six-cylinder classic.

The MGC is part of the classic MG range, the six-cylinder member of the family, built for just two years and now appreciated for exactly the qualities that were once held against it.

A six-cylinder MGB

The car arrived in 1967, built on the MGB’s bodyshell so closely that most people cannot tell the two apart at a glance. The giveaways are a bonnet with a prominent power bulge, needed to clear the taller engine and a relocated radiator, and 15-inch wheels in place of the MGB’s 14-inch ones. It was conceived under BMC partly as a replacement for the Austin-Healey 3000, which American safety rules were about to kill off, and it came as both a roadster and the fastback GT.

To carry the weight of the big six, MG gave it a bespoke front suspension using longitudinal torsion bars, quite different from the MGB’s coil springs. It is a robust set-up, but it is one of the things that makes the MGC its own car rather than just an MGB with a bigger engine.

The engine, and the handling reputation

The single most common mistake about the car is to call its engine the old Austin-Healey 3000 unit. It is not. The MGC uses a 2912cc C-series straight-six that is closely related to that engine but significantly redesigned, with seven main bearings instead of four and properly spaced bores with coolant between the cylinders. BMC set out to make it much lighter and largely failed, saving only around 20 kg, so it remains a heavy iron six producing 145 bhp.

That weight is the root of the car’s reputation. With about 56 per cent of its mass over the front wheels, the car understeers and feels nose-led, and the press of 1967 savaged it for heavy steering and a lack of agility. What is now widely understood is that the press demonstrator cars went out with badly underinflated front tyres, which exaggerated the problem and fixed an unfair reputation in print. Set the pressures correctly, fit good dampers and fresh bushes, and a sorted MGC is a smooth, torquey, relaxed grand tourer. It was never meant to be a corner-carver; it was meant to cover long distances quickly and comfortably, and at that it succeeds.

Roadster, GT and the University Motors Specials

It came as an open roadster and as the Pininfarina-roofed GT, mechanically identical and built in roughly equal numbers, about 9,000 in total across the two years. The GT is the natural long-distance cruiser; the roadster is usually the more sought-after and valuable today.

There is also a footnote worth knowing. When production ended, the London distributor University Motors bought up unsold cars and re-marketed a number of them as University Motors MG Specials, some with Downton Engineering tuning and various cosmetic touches. No two were quite alike, and genuine examples are now especially collectable.

What it is like to own

A good MGC is a lovely thing to cover ground in. The straight-six is smooth and immensely torquey, pulling lazily from low revs, and with overdrive it is a genuinely relaxed high-speed tourer good for around 120 mph. It is heavier in the steering than an MGB and happiest on open roads rather than tight lanes, but that suits its grand-touring character. It shares the MGB’s simplicity and much of its parts supply, so it is no harder to live with day to day than its four-cylinder sibling.

Buying guide: what to look for

It rusts in all the same places as the MGB, so the sills, floors, wheel arches, boot floor and battery boxes are the priorities, and the sills are structural. Sagging doors and uneven gaps point to sill rot.

Then there are the MGC-specific checks. Inspect the box sections under the floor that carry the torsion bars, because these corrode and are not currently reproduced, making rot here a serious problem. Check the condition and cooling of the six, which sits in a tight, hot engine bay, and be aware that the original aluminium bonnet is rare and expensive to replace. Parts supply is good overall thanks to MGB commonality, but C-specific items, the engine, the front suspension and some trim, are scarcer and dearer, so budget accordingly.

Current value and where it sits

The MGC has moved from bargain to steadily appreciating. Projects sit around £6,000 to £9,000, good cars between £12,000 and £18,000, and excellent examples between £25,000 and £32,000, with the best cars and genuine University Motors Specials beyond. Roadsters lead GTs. It is still widely seen as undervalued next to the cars it sits between.

In the wider story the MGC is the six-cylinder MG that was unfairly judged, the intended heir to the Austin-Healey 3000 and a cheaper six-cylinder alternative to the Jaguar E-Type 2+2. MG’s other route to more performance was the lighter, better-balanced MGB GT V8, which made similar pace without the nose-heavy handling. For the wider period it belongs to, see British classic cars of the 1960s.

Owners’ clubs and parts

The MG Car Club and the MG Owners’ Club both cover the MGC, with technical support, dating and a dedicated following. Parts supply benefits hugely from MGB commonality, with body panels and much mechanical kit shared, but the C-specific engine, front suspension and trim parts are harder to find and more expensive, so factor that into any restoration.

Related

The MGC is one of the classic MGs, the six-cylinder version of the MGB. For a lighter route to performance, see the MGB GT V8, and for the wider period it belongs to, see British classic cars of the 1960s.

More photos